cable

I used wiring from a dead PC power supply. Also at the top, though it's not shown very well, is a small PCB with a removable terminal block. It's kind of like the screw terminals on the extruder controller, however it plugs onto peg terminals, so you ...

I used wiring from a dead PC power supply. Also at the top, though it's not shown very well, is a small PCB with a removable terminal block. It's kind of like the screw terminals on the extruder controller, however it plugs onto peg terminals, so you can remove the block without unscrewing things. I salvaged these from the control boards of an old building security system.

Posted by krux on Fri 10 Sep 2010 02:48:54 AM PDT

Makerbot wiring

Hello,

What type of cable did you use to extend the DC motor of the extruder?

Thanks,
AM

Posted by Mando (guest) on Tue 07 Sep 2010 11:51:03 AM PDT